New type clutch friction plate for models with deep splines with deep splined centre

2 plates required- thicker side of each friction plate should face transmission.
Also known as Guzzi ref. 30084410, 03084400, 29084450
V11 Tenni, Rosso Mandello and Scura have a single plate clutch which uses a different friction plate (unfortunately out of production)

These can be fitted to earlier 850 and 1000 models if the early shallow splined clutch centre is replaced with the later deep splined type. See our kit CLA20302 to update early 850/1000 models. Clutch plate alignment tool also available, see TOA30510

 4 in stock

 05084430 GU05084430 05 08 44 30
 0508 4430 0508.4430 05.08.44.30

Oil pressure sender, M12 thread, male bullet connector

Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 More than 5 in stock

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Polished Brembo aluminium brake lever

Also known as Guzzi ref. 10270652. Brembo ref. 110489431, AP8161262. Can be used instead of adjustable lever BRA81510 for Breva 1200, 1200 Sport, Norge etc... Replaces Guzzi ref. 2B003821 and 2B003041

 1 in stock

 03605645 GU03605645 03 60 56 45
 0360 5645 0360.5645 03.60.56.45

1 litre of Millers 85w-140 mineral based final drive oil. Excellent anti-wear characteristics plus chemical stability and oxidation resistance to keep bearings and gears in optimum condition. This also allows long drain intervals

An extreme pressure drive box oil SAE 85w140 mineral based differential oil with performance additives. Use as received in Hypoid differentials requiring extreme pressure lubricants and GL5 specification.

Provides performance level specified by manufacturers for axles and final drives.
Low friction transmission oil reduces axle noise.No need to use separate moly additive with this oil.

170ml required for bevel box lubrication on all models except V9 which uses 210ml

Please note this part CANNOT be posted outside of the UK mainland area

 More than 5 in stock

Dellorto carb gasket kit / rebuild kit for PHF30, contains necessary rubber seals and gaskets to recondition a carburettor

Carb overhaul kit, fuel filter FUA60888 and float bowl seal FUA90001 available separately to this seal kit

 2 in stock

 28939911 GU28939911 28 93 99 11
 2893 9911 2893.9911 28.93.99.11

Brakelight switch for handlebar mounted master cylinder

Stop light switch also known as Guzzi ref. 30530526. Please compare with your existing switch to check compatibility. Can be used as a substitute for ELA27815. See ELA30861 for less expensive alternative part. Sometimes supplied with three terminals, in this instance disregard middle terminal

 3 in stock

 30749860 GU30749860 30 74 98 60
 3074 9860 3074.9860 30.74.98.60

Dust cover for fork leg, seals against stanchion to protect fork seal

 More than 5 in stock

14524500-z 14524500 GU14524500 14 52 45 00
 1452 4500 1452.4500 14.52.45.00

Carb gasket kit / rebuild kit for Dellorto VHB29, VHB30, VHB24 and VHB26 carbs

Carb overhaul kit, fuel filter FUA60888 and float bowl seal FUA90001 available separately to this seal kit. As this kit is intended for several different carbs you may have gaskets or O rings remaining after rebuilding. More information on rebuilding your VHB carb can be found here.

 More than 5 in stock

 17939950 GU17939950 17 93 99 50
 1793 9950 1793.9950 17.93.99.50

Black rubber UJ gaiter / boot, clips available separately

 3 in stock

 19548001 GU19548001 19 54 80 01
 1954 8001 1954.8001 19.54.80.01

Lower Throttle cable

This runs from the splitter to the carb. We advise you to measure your existing cable before ordering in case you have a non standard set up.

 4 in stock

 29117750 GU29117750 29 11 77 50
 2911 7750 2911.7750 29.11.77.50