Air filter, flat paper cartridge type

See SIA10425 for a reusable performance air filter

AP8104242

Dimensions:
115mm x 155mm x 28mm

Taper needle roller bearing used as steering head bearing

2 sets required per bike. Also used as rear drive box pinion bearing on big twins with rear drum brake

 92249225 GU92249225 92 24 92 25
 9224 9225 9224.9225 92.24.92.25

Clutch cable with adjuster for gearbox end

Suitable for all T3 and T4 models fitted with high bars

29093000-z 29093000 GU29093000 29 09 30 00
 2909 3000 2909.3000 29.09.30.00

Dimensions:
1444mm outer length, 80mm free length, 9.9mm barrel nipple, 9.9mm barrel nipple

Carb gasket kit / rebuild kit for Dellorto PHBH carbs

Carb overhaul kit, float bowl seal FUA90001, fuel filter FUA60888 and float bowl washer FUA27720 available separately to this carb seal kit

 19939980 GU19939980 19 93 99 80
 1993 9980 1993.9980 19.93.99.80

Reset knob for odometer

 28762860 GU28762860 28 76 28 60
 2876 2860 2876.2860 28.76.28.60

Dimensions:
40mm overall length, conventional thread

Full service kit for pre PI engine EV models containing 1 x UFI or Mahle oil filter, 1 x UFI air filter, 2 x NGK BPR6ES spark plugs, 1 x sump gasket, 2 x rocker cover gaskets, O ring and all crush washers to complete a service on your bike

Save £'s by buying everything in a service kit

See FUA29106 for fuel filter, ENA95006 for gauze oil filter tab washer. Oils and lubricants available separately. The oils you need are 1 x OIA01152 and 1 x OIA08194 or save time and money by ordering service oil kit OIA18004 with your service kit.

Rocker cover screw kit containing 16 replacement stainless steel socket cap bolts for round and square barrel engine rocker covers. Only one kit required per engine

To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070). This kit is for models with billet rocker cover protectors fitted as these models need 8 of the bolts to be longer

Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK CPR8EB-9 spark plugs, crush washers and filter cover O ring to complete a service on your bike. Please note if SIA27300 is out of stock due to availability issues we will substitute it with a like for like oil filter to maintain the availability of Kits

Save £'s by buying everything in a service kit

Oils and lubricants available separately. The oils you need are 2 x OIA01071 + 1 x OIA08296 + 1 x OIA08193. See FUA01090 for fuel filter

Exhaust stud kit consisting of 4 x titanium studs, 4 x stainless dome head nuts and 4 x stainless wavy washers

The mild steel exhaust studs fitted to modern Guzzis are notorious for corroding in place. Replace yours now with these corrosion resistant parts to ensure you can remove your exhaust in years to come

1A003632R

Dimensions:
M8 x 48mm studs

Kit containing 6 titanium shouldered retaining screws for rocker cover. Upgrade your corrosion prone zinc OE parts with a polished upgrade. Note that one bolt on each cover is hidden under a plastic cover, if you would prefer to only buy four bolts then see SSA84291

Rocker cover bolt kit. We recommend that you check length of bolts on your engine before ordering as two lengths of bolt were used. Supercedes Guzzi ref. 976591
See ENA83249 for rubber sealing washer

 842291 MG842291

Dimensions:
M6 x 13mm