Sealed bearing used as rear wheel bearing on some models

1 only required for rear wheel bearing applications

92204218-z 92204218 GU92204218 92 20 42 18
 9220 4218 9220.4218 92.20.42.18

Dimensions:
47mm OD

Taper needle roller bearing used as steering head bearing

2 sets required per bike. Also used as rear drive box pinion bearing on big twins with rear drum brake

 92249225 GU92249225 92 24 92 25
 9224 9225 9224.9225 92.24.92.25

Oil pressure sender, M12 thread, male bullet connector

This oil pressure sensor supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Dimensions:
M12 thread, 46mm x 21mm bolt flats

Carb gasket kit / rebuild kit for Dellorto PHBH carbs

Carb overhaul kit, float bowl seal FUA90001, fuel filter FUA60888 and float bowl washer FUA27720 available separately to this carb seal kit

 19939980 GU19939980 19 93 99 80
 1993 9980 1993.9980 19.93.99.80

Carb gasket kit / rebuild kit for Dellorto VHB29, VHB30, VHB24 and VHB26 carbs

Carb overhaul kit, fuel filter FUA60888 and float bowl seal FUA90001 available separately to this seal kit. As this kit is intended for several different carbs you may have gaskets or O rings remaining after rebuilding. More information on rebuilding your VHB carb can be found here.

 17939950 GU17939950 17 93 99 50
 1793 9950 1793.9950 17.93.99.50

Manual left hand petrol tap with nut and filter. On, Off and Reserve settings.

Point on lever faces back in off position. Can be used to replace electronic fuel solenoid valve 37105305

17105461-z 17105461 GU17105461 17 10 54 61
 1710 5461 1710.5461 17.10.54.61

Dimensions:
16mm threaded section, 8mm fuel pipe spigot

Round 12v two pin flasher relay

See FRA17720 for rubber mount, item may look different to this please take into consideration before ordering.

 17750520 GU17750520 17 75 05 20
 1775 0520 1775.0520 17.75.05.20

Dimensions:
32mm diameter

Carb gasket kit / rebuild kit for Dellorto VHB29, VHB30, VHB24 and VHB26 carbs

Carb overhaul kit, fuel filter FUA60888 and float bowl seal FUA90001 available separately to this seal kit. As this kit is intended for several different carbs you may have gaskets or O rings remaining after rebuilding. More information on rebuilding your VHB carb can be found here.

 17939950 GU17939950 17 93 99 50
 1793 9950 1793.9950 17.93.99.50

Oil pressure sender, M12 thread, male bullet connector

This oil pressure sensor supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Dimensions:
M12 thread, 46mm x 21mm bolt flats

Pair of ignition points (made up of Guzzi part numbers 14715429 and 14715430)

 14719800 GU14719800 14 71 98 00
 1471 9800 1471.9800 14.71.98.00