Round 12v two pin flasher relay

See FRA17720 for rubber mount

 More than 5 in stock

 17750520 GU17750520 17 75 05 20
 1775 0520 1775.0520 17.75.05.20

Inlet rubber with HT lead guide

Fits between exhaust manifold on cylinder head and carb. Use hose clip SSA45970. Suitable for PHF30 and PHF36 carbs

 More than 5 in stock

14114350-z 14114350 GU14114350 14 11 43 50
 1411 4350 1411.4350 14.11.43.50

Special nut for retaining crankshaft timing sprocket. Also used as clutch centre nut on V11 Sport

See TOA18651 for special tool to remove and tighten this nut. Nut also known as Guzzi ref. 93601025. See ENA92525 for correct part for series 2 Cali 1100s

 4 in stock

 93601026 GU93601026 93 60 10 26
 9360 1026 9360.1026 93.60.10.26

Full engine seal kit, includes all necessary seals for a complete engine overhaul

Full gasket sets also available, see ENA17550 if you also need the gearbox seals. Can also be fitted to models equipped with a Saprisa charging system if front crank oil seal ENA94238 is ordered

 More than 5 in stock

17999550-z 17999550 GU17999550 17 99 95 50
 1799 9550 1799.9550 17.99.95.50

Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK BP6ES spark plugs, 1 x sump gasket, 2 x rocker cover gaskets and all crush washers to complete a service on your round barrel model with electronic ignition.

Save time and hassle by ordering service oil kit OIA14001 with your service kit

Save £'s by buying everything in a service kit

For models with points see SIA14001, if you have a deep sump you'll need an extra sump gasket (ENA14036). Oils and lubricants available separately. The oils you need are 1 x OIA11036 and 1 x OIA08194. See ENA95006 for gauze oil filter tab washer

 More than 5 in stock

Full service kit containing 1 x UFI oil filter, 2 x NGK BP7ES spark plugs, 1 x sump gasket, 2 x rocker cover gaskets and all crush washers to complete a service on your round barrel Le Mans with electronic ignition.

Save time and hassle by ordering service oil kit OIA14001 with your service kit

Save £'s by buying everything in a service kit

For models with points see SIA14003, if you have a deep sump you'll need an extra sump gasket (ENA14036). Oils and lubricants available separately. See ENA95006 for gauze oil filter tab washer. The oils you need are 1 x OIA11036 and 1 x OIA08194

 More than 5 in stock

Full service kit for twin throttle body models containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK BR8ES spark plugs, 2 x rocker cover gaskets and all crush washers and O rings to complete a service on your bike

Save £'s by buying everything in a service kit

Oils and lubricants available separately. The oils you need are 2 x OIA01051 1 x OIA08194 + 1 x OIA08193. Order service oil kit OIA28001 if you require oil with your service parts. See FUA01090 for fuel filter. Single throttle body 2012 onwards models will need service kit SIA28002 instead- if in doubt check which type of spark plugs your bike has.

 This part is due back in stock soon, call 01484 841395 to reserve yours

Stainless steel fasteners kit for PHF and PHM carb models without sump extension.This kit contains nuts, bolts and washers for the following: distributor clamp, rocker covers, timing cover, gearbox bell housing, alternator cover, gearbox rear cover, neutral switch, drive box to swingarm, starter motor, head studs, exhaust flanges, inlet manifolds and sump. Just what you need to brighten up your Guzzi and ensure nuts and bolts don't seize on your bike

This engine bolt kit contains appropriate M6, M8, M10 socket cap and hex head bolts, nuts and washers. 149 pieces. To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070). You may also require a replacement front engine bolt kit in stainless (SSA14450) or distributor screws (SSA05025 and SSA04008)

 More than 5 in stock

Rocker cover screw kit containing 16 replacement stainless steel socket cap bolts for round and square barrel engine rocker covers. Only one kit required per engine

To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070). This kit is for models without billet rocker cover protectors fitted, for models with rocker cover protectors see SSA80015. This kit will suit a V11 with standard rocker cover protectors which are much thinner than aftermarket types.

See SSA81522 for rocker cover trim retaining screws on 2v/cyl CARC models, these are not included with this kit.

 More than 5 in stock

The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Booster plug removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Lifetime warranty

 This part is due back in stock soon, call 01484 841395 to reserve yours