Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 3 Ohm 12 volt coils and can be used to replace points or Motoplat ignition on models with Saprisa charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA31165

 This part is available by special order, request a quote

Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.

This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11

Brand new right hand original "Lego" type switchgear and twistgrip with switches for starter and run/kill.
Previously unavailable new and ideal for your restoration project.

Comes with attached 4 pin molex connector, molex pins and rubber boot, ready to be plugged into your standard loom. Twistgrip for standard dual throttle cables.

See ELA17061 and ELA14055 for left hand switches.

 Sorry, this part is no longer available.

Round 12v two pin flasher relay for LED indicators. For use with aftermarket LED indicators

Includes rubber for attaching to bike.

NB Only suitable for LED indicators. Will not work in modern V7 models because these do not utilise a flasher unit.

 This part is available by special order, request a quote

Pair of low and high chrome Voxbell Fiamm type snail horns. Very loud and Italian!

Chromed plastic grill and cover, also known as Guzzi ref. 28743761. Sold with brackets, can be fitted to most Guzzis

 This part is available by special order, request a quote

28743760-z 28743760 GU28743760 28 74 37 60
 2874 3760 2874.3760 28.74.37.60

Screw in brakelight switch for linked system proportioning valve or splitter

Screws into yoke mounted manifold for hand brake

 This part is available by special order, request a quote

 25657001 GU25657001 25 65 70 01
 2565 7001 2565.7001 25.65.70.01

Complete shallow bowl 190mm chrome headlight unit. Includes a pilot / parking light. A shallow bowl makes it especially suitable for mounting on Moto Guzzis underneath the instruments

Homologated for road use.

Supplied complete with H4 bulb, pilot light and four short wires (without connectors). This headlight will fit fairing cowling FAA99575 for Le Mans 1 conversions if trim strip is not fitted to inside edge of fairing. NB mounting holes will need drilling out to 10mm if fitting T3 type indicator stems

 Availability varies on this part, check availability

Complete shallow bowl 190mm gloss black headlight unit.

Fits Le Mans 1 headlamp cowling FAA99575. Supplied complete with bulb and three short wires (without connectors). NB mounting holes will need drilling out to 10mm if fitting T3 type indicator stems. Neutral beam pattern and not E Marked

 This part is due back in stock soon, call 01484 841395 to reserve yours

Red NGK spark plug resistor cap with rubbers

Also known as suppressor cap

 This part is due back in stock soon, call 01484 841395 to reserve yours

Complete shallow bowl 193mm satin black LED headlight unit. Bright, neutral beam pattern will pass an MOT and illuminates the road much better than a halogen unit. Classic looks suit models from the Le Mans 1 to the V9

Fits Le Mans 1 headlamp cowling FAA99575. Also perfect for custom builds, cafe racers and specials. NB mounting holes will need drilling out to 10mm if fitting T3 type indicator stems. Neutral beam pattern and not E Marked.
Tried and tested on our bikes at Gutsibits

 This part is available by special order, request a quote