Lower Gasket for oil sump flange
See ENA14036 for upper sump flange gasket
More than 5 in stock
01003600-z 01003600 GU01003600 01 00 36 00
0100 3600 0100.3600 01.00.36.00
£8.00
INC VAT
£6.67 EX VAT
Rear crankcase oil seal or rear main oil seal.
Fits Nevada 750 up to engine LT017877 and Nevada 350 to engine PC053625. Also known as Guzzi ref. 90405368. We recommend replacing the rear crank oil seal when replacing the clutch
More than 5 in stock
90405367-z 90405367 GU90405367 90 40 53 67
9040 5367 9040.5367 90.40.53.67
£14.00
INC VAT
£11.67 EX VAT
Cartridge oil filter UFI 23 149 00
Fits Daytona 1000 models where filter screws into base of sump. This is an 8 sided UFI filter.
Use tool TOA41006 if your filter is located inside the sump, use tool TOA01201 if you change your oil filter without removing the sump.
You may also require SIA10070 which is the crush washer for the drain plug and ENA14036 (sump gasket).
Please note that Daytona RS and T5 Polizia use filter SIA15300
More than 5 in stock
14153000 GU14153000 14 15 30 00
1415 3000 1415.3000 14.15.30.00
£10.50
INC VAT
£8.75 EX VAT
UFI 25 46 500 cartridge oil filter. See TOA19001 for a inexpensive tool to loosen and tighten the dipstick
For post 1989 V35, V50 and V65 models use SIA27300 .
NB Packaging may vary. For an oil change we also recommend 1x ENA90444 (Oil filter cover O ring), 1 x SIA10070 (large sump drain crush washer), 1 x SIA10900 (small sump drain crush washer) and 1 x SIA12200 (filter cover crush washer)
More than 5 in stock
19153000 GU19153000 19 15 30 00
1915 3000 1915.3000 19.15.30.00
£8.50
INC VAT
£7.08 EX VAT
Used in place of Guzzi ref. AP8125841
2 in stock
AP8125773
£23.00
INC VAT
£19.17 EX VAT
Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.
This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.
Supercedes Guzzi refs. 12730705, 14730554 and 14730705
Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part
1 in stock
30730711 GU30730711 30 73 07 11
3073 0711 3073.0711 30.73.07.11
£231.00
INC VAT
£192.50 EX VAT
Brush holder for Bosch alternator stator
Also known as Guzzi ref. 17712454, 14712452
Includes brushes. See ELA17453
1 in stock
17712452 GU17712452 17 71 24 52
1771 2452 1771.2452 17.71.24.52
£68.30
INC VAT
£56.92 EX VAT
UFI 30 989 00 flat type air filter, paper filament in rubber surround
See SIA30361 for a reusable K & N air filter
More than 5 in stock
30113600 GU30113600 30 11 36 00
3011 3600 3011.3600 30.11.36.00
£12.00
INC VAT
£10.00 EX VAT
Clutch pushrod for RAM clutch which is 5mm longer than the standard version. This may be needed when fitting a RAM clutch kit to give extra room for adjustment
1 in stock
£37.30
INC VAT
£31.08 EX VAT
Opening throttle cable
Also see closing cable CAA01580 . Only one cable is required. We advise you to measure your existing cable before ordering in case you have a non standard set up
1 in stock
01117580 GU01117580 01 11 75 80
0111 7580 0111.7580 01.11.75.80
£21.00
INC VAT
£17.50 EX VAT