Lower throttle cable
We advise you to measure your existing cable before ordering in case you have a non standard set up
2 in stock
12117501-z 12117501 GU12117501 12 11 75 01
1211 7501 1211.7501 12.11.75.01
£6.10
INC VAT
£5.08 EX VAT
Full engine and gearbox seal kit, includes all necessary seals for a complete engine and gearbox overhaul.
Full gasket sets also available. Can also be fitted to models equipped with a Saprisa charging system if front crank oil seal ENA94238 is ordered
2 in stock
17999550 GU17999550 17 99 95 50
1799 9550 1799.9550 17.99.95.50
£75.00
INC VAT
£62.50 EX VAT
Carb gasket kit / rebuild kit for Dellorto PHBH carbs
Carb overhaul kit, float bowl seal FUA90001, fuel filter FUA60888 and float bowl washer FUA27720 available separately to this carb seal kit
More than 5 in stock
19939980 GU19939980 19 93 99 80
1993 9980 1993.9980 19.93.99.80
£13.50
INC VAT
£11.25 EX VAT
Dellorto choke piston or plunger for Dellorto VHB, PHBH, PHF and PHM carbs. Includes rubber seal in end of plunger
More than 5 in stock
13937800 GU13937800 13 93 78 00
1393 7800 1393.7800 13.93.78.00
£6.20
INC VAT
£5.17 EX VAT
Rubber rocker gasket for left hand cylinder. See ENA87742 for right hand side
1 in stock
872741 MG872741
£15.50
INC VAT
£12.92 EX VAT
Rubber rocker gasket for right hand cylinder. See ENA87741 for left hand side
1 in stock
872742 MG872742
£15.50
INC VAT
£12.92 EX VAT
Carb mounted flip choke with plunger, lever, O ring, casting and spring. Insufficient clearance on high top carbs to operate the choke and the throttle cable
Fits all PHF30 - PHF36 and VHB30 Dellorto flat top carbs, contains rubber seat insert. Allows you to eliminate the choke cables and any handlebar choke controls for a cleaner look, especially suitable for special builds
2 in stock
14937800 GU14937800 14 93 78 00
1493 7800 1493.7800 14.93.78.00
£21.80
INC VAT
£18.17 EX VAT
Silencer clamp gasket / shim or muffler gasket used to seal crossover to silencer
This exhaust bush is not required if a Mistral or Agostini silencer is fitted
1 in stock
05128230 GU05128230 05 12 82 30
0512 8230 0512.8230 05.12.82.30
£25.00
INC VAT
£20.83 EX VAT
Rear crankcase oil seal or rear main oil seal.
Fits Nevada 750 up to engine LT017877 and Nevada 350 to engine PC053625. Also known as Guzzi ref. 90405368. We recommend replacing the rear crank oil seal when replacing the clutch
More than 5 in stock
90405367-z 90405367 GU90405367 90 40 53 67
9040 5367 9040.5367 90.40.53.67
£14.00
INC VAT
£11.67 EX VAT
UFI 25 46 500 cartridge oil filter. See TOA19001 for a inexpensive tool to loosen and tighten the dipstick
For post 1989 V35, V50 and V65 models use SIA27300 .
NB Packaging may vary. For an oil change we also recommend 1x ENA90444 (Oil filter cover O ring), 1 x SIA10070 (large sump drain crush washer), 1 x SIA10900 (small sump drain crush washer) and 1 x SIA12200 (filter cover crush washer)
More than 5 in stock
19153000 GU19153000 19 15 30 00
1915 3000 1915.3000 19.15.30.00
£8.50
INC VAT
£7.08 EX VAT