Carb gasket kit / rebuild kit for 1 Dellorto PHF carb. Suitable for all PHF carbs with accelerator pumps including PHF36. Dellorto ref. 52514-77

Carb overhaul kit, float bowl seal FUA90001 and fuel filter FUA60888 also available separately to this carb seal kit

 More than 5 in stock

 14939950 GU14939950 14 93 99 50
 1493 9950 1493.9950 14.93.99.50

Also fits Hesketh, Laverda

Rear light lens with reflector

Attaches via 2 screws (not included)

 1 in stock

10741700-z 10741700 GU10741700 10 74 17 00
 1074 1700 1074.1700 10.74.17.00

Head Gasket

 5 in stock

 30022060 GU30022060 30 02 20 60
 3002 2060 3002.2060 30.02.20.60

Inlet rubber with HT lead guide. This part will only fit the PHM40 carbs with 43.5mm inlet stubs, we recommend measuring your carbs before ordering

Fits between exhaust manifold on cylinder head and carb. Use clip SSA45970

 4 in stock

28114360-z 28114360 GU28114360 28 11 43 60
 2811 4360 2811.4360 28.11.43.60

Polished Brembo aluminium brake lever

Also known as Guzzi ref. 10270652. Brembo ref. 110489431, AP8161262. Can be used instead of adjustable lever BRA81510 for Breva 1200, 1200 Sport, Norge etc... Replaces Guzzi ref. 2B003821 and 2B003041

 1 in stock

 03605645 GU03605645 03 60 56 45
 0360 5645 0360.5645 03.60.56.45

Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK BP6ES spark plugs, 2 x condensers, 1 x set points, 1 x sump gasket, 2 x rocker cover gaskets and all crush washers to complete a service on your points equipped round barrel model.

Save time and hassle by ordering service oil kit OIA14001 with your service kit

Save £'s by buying everything in a service kit

For models with electronic ignition see SIA14002, if you have a deep sump you'll need an extra sump gasket (ENA14036). Oils and lubricants available separately. The oils you need are 1 x OIA11036 and 1 x OIA08194. See ENA95006 for gauze oil filter tab washer

 This part is due back in stock soon, call 01484 841395 to reserve yours

Basic service kit (no air filter) containing 1 x UFI oil filter, 2 x NGK BP7ES spark plugs, 2 x rocker cover gaskets and all crush washers and O rings to complete a service on your bike. Depending on model you may also require points (SIA19715), condensers (SIA19786) and air filter (SIA17113 for conical air filter, SIA28113 for flat type air filter)

Save £'s by buying everything in a service kit

Oils and lubricants available separately. The oils you need are 1 x OIA11036 and 1 x OIA08194 + 1 x OIA08193 or save time and hassle by ordering service oil kit OIA19000 with your service kit.

 More than 5 in stock

Sump bolt kit containing all replacement stainless steel socket cap bolts for models with a sump extension fitted. Some models e.g. Cali 1100 and series 1 Cali EV models have a sump extension fitted as standard

To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070). For Cali EV models check whether you have a sump extension fitted, the later one piece deep sump uses SSA80008

 More than 5 in stock

4 pin mini relay

Also known as Guzzi ref. 30732560, 01732530

 More than 5 in stock

 01732560 GU01732560 01 73 25 60
 0173 2560 0173.2560 01.73.25.60

The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Booster plug removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Lifetime warranty

 This part is due back in stock soon, call 01484 841395 to reserve yours