Rear crankcase oil seal or rear main oil seal.

Fits Nevada 750 up to engine LT017877 and Nevada 350 to engine PC053625. Also known as Guzzi ref. 90405368. We recommend replacing the rear crank oil seal when replacing the clutch

 More than 5 in stock

90405367-z 90405367 GU90405367 90 40 53 67
 9040 5367 9040.5367 90.40.53.67

UFI 25 46 500 cartridge oil filter. See TOA19001 for a inexpensive tool to loosen and tighten the dipstick

For post 1989 V35, V50 and V65 models use SIA27300 .
NB Packaging may vary. For an oil change we also recommend 1x ENA90444 (Oil filter cover O ring), 1 x SIA10070 (large sump drain crush washer), 1 x SIA10900 (small sump drain crush washer) and 1 x SIA12200 (filter cover crush washer)

 More than 5 in stock

 19153000 GU19153000 19 15 30 00
 1915 3000 1915.3000 19.15.30.00

Complete Speedo (odometer) cable

We advise you to measure your existing cable before ordering in case you have a non standard set up.

 1 in stock

61760440-z 61760440 GU61760440 61 76 04 40
 6176 0440 6176.0440 61.76.04.40

Brush holder for Bosch alternator stator

Also known as Guzzi ref. 17712454, 14712452

Includes brushes. See ELA17453

 1 in stock

 17712452 GU17712452 17 71 24 52
 1771 2452 1771.2452 17.71.24.52

Fuel pipe assembly including crossover for VHB24 and VHB26 square slide carbs with narrow fuel unions

See FUA00004 for pipe clips

 3 in stock

 19106550 GU19106550 19 10 65 50
 1910 6550 1910.6550 19.10.65.50

Standard grey tinted screen for headlamp fairing. Includes screen edge trim.

Fitting kits available separately. Screen fasteners are FAA98417 x 3, FAA04001 x 6, FAA90035 x 3, FAA92104 x 3

 2 in stock

14577250-z 14577250 GU14577250 14 57 72 50
 1457 7250 1457.7250 14.57.72.50

UFI 30 989 00 flat type air filter, paper filament in rubber surround

See SIA30361 for a reusable K & N air filter

 More than 5 in stock

 30113600 GU30113600 30 11 36 00
 3011 3600 3011.3600 30.11.36.00

Front brake master cylinder cap and rubber kit for Brembo PS 13 master cylinder. Check the screw holes in your master cylinder are diagnally opposed (as seen top left and bottom right corners when sitting on bike)

Reservoir cap replaces Guzzi ref. 2B001928

 1 in stock

 03661145 GU03661145 03 66 11 45
 0366 1145 0366.1145 03.66.11.45

Cable splitter box for models with a single cable from the choke or throttle, high quality replacement item from Domino

 2 in stock

 30607910 GU30607910 30 60 79 10
 3060 7910 3060.7910 30.60.79.10

Single stainless steel M10 banjo bolt with bleed nipple for Brembo fittings. Supplied with bleed nipple cap and crush washers. Perfect for bleeding up old P9, F08 and F05 calipers where the bleed nipple has broken off. This can also be used to add additional bleed points to linked systems where airlocks are causing problems

These can be used to replace the standard banjo bolt on CARC models. See alternative part BRA41653 for Stahlbus auto bleed banjo bolt

 More than 5 in stock

Also fits Benelli 250 TS