Dimensions:
Outer 1655mm free length 100mm
Clutch cable with adjuster for gearbox end
1 in stock
13093048 GU13093048 13 09 30 48
1309 3048 1309.3048 13.09.30.48
£17.10
INC VAT
£14.25 EX VAT
Dimensions:
1126mm outer, 76mm free length
Clutch cable with adjuster for gearbox end
1 in stock
12093045 GU12093045 12 09 30 45
1209 3045 1209.3045 12.09.30.45
£17.10
INC VAT
£14.25 EX VAT
Dimensions:
1315mm outer length, 170mm free length, 9.9mm barrel nipple, 10mm barrel nipple
Clutch cable without adjuster
We advise you to measure your existing cable before ordering in case you have a non standard set up.
1 in stock
23093080-z 23093080 GU23093080 23 09 30 80
2309 3080 2309.3080 23.09.30.80
£14.40
INC VAT
£12.00 EX VAT
Dimensions:
85mm OD
Rear light lens with reflector
Attaches via 2 screws (not included)
1 in stock
10741700-z 10741700 GU10741700 10 74 17 00
1074 1700 1074.1700 10.74.17.00
£8.00
INC VAT
£6.67 EX VAT
Dimensions:
70mm x 21mm overall
Gearbox ratchet return spring
These are a weak point on the V11 so its worth keeping a spare on the shelf
2 in stock
04238300 GU04238300 04 23 83 00
0423 8300 0423.8300 04.23.83.00
£9.00
INC VAT
£7.50 EX VAT
Dimensions:
48mm x 27mm
Gearbox return spring
1 in stock
04238200 GU04238200 04 23 82 00
0423 8200 0423.8200 04.23.82.00
£7.20
INC VAT
£6.00 EX VAT
Dimensions:
16mm threaded section, 8mm fuel pipe spigot
Manual petrol tap with nut and filter. On and off settings.
Point on lever faces back in off position. Used for RH applications on some models. TAA65401A or TAA65401B can be substituted for this part. Used for LH and RH fuel tap on Cali 1100
1 in stock
23105470-z 23105470 GU23105470 23 10 54 70
2310 5470 2310.5470 23.10.54.70
£16.00
INC VAT
£13.33 EX VAT
Dimensions:
Length 183mm Width 57mm
Rubber intake sleeve for airbox
1 in stock
12114301 GU12114301 12 11 43 01
1211 4301 1211.4301 12.11.43.01
£17.50
INC VAT
£14.58 EX VAT
Dimensions:
30mm internal diameter x 39mm
Inlet rubber
Fits between exhaust manifold on cylinder head and carb. Use clip SSA25950
More than 5 in stock
61114300-z 61114300 GU61114300 61 11 43 00
6111 4300 6111.4300 61.11.43.00
£9.00
INC VAT
£7.50 EX VAT
Dimensions:
M12 x 1 thread, 32mm height from top of thread
Oil pressure switch. May be supplied with a vertical spade connector, this supercedes the original Guzzi part which is no longer available. This version will fit without removal of the alternator
See ENA12640 for replacement crush washer and ELA10005 for female spade connector
3 in stock
31768780 GU31768780 31 76 87 80
3176 8780 3176.8780 31.76.87.80
£11.00
INC VAT
£9.17 EX VAT
Secure online shopping 
