Shop headings: New Spares | Used Spares | Accessories | Brands
33 Results - Page 2 of 4
Stainless steel fasteners kit for PHF and PHM carb models with sump extension.This kit contains nuts, bolts and washers for the following: rocker covers, timing cover, gearbox bell housing, alternator cover, gearbox rear cover, neutral switch, drive box to swingarm, starter motor, head studs, exhaust flanges, inlet manifolds and sump. Just what you need to brighten up your Guzzi and ensure nuts and bolts don't seize on your bike
This engine bolt kit contains appropriate M6, M8, M10 socket cap and hex head bolts, nuts and washers. 149 pieces. To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070). You may also require a replacement front engine bolt kit in stainless (SSA14450) or distributor screws (SSA05025 and SSA04008)
More than 5 in stock
£85.00
INC VAT
£70.83 EX VAT
Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 3 Ohm 12 volt coils and can be used to replace points or Motoplat ignition on models with Saprisa charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.
2 year warranty on Sachse ignition kits
Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA31165
This part is available by special order, request a quote
£395.00
INC VAT
£329.17 EX VAT
Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 12 volt coils and can be used to replace points or Bosch electronic ignition on models with Bosch charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.
2 year warranty on Sachse ignition kits
Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. We recommend fitting Dyna coils ELA14101 with this kit. If you wish to combine this kit with uprated charging system ELA00502 you will need to make or source longer studs (M5 x 67mm x 2) for pickup, and longer centre bolt (M8 x 58mm wasted). See ACA50001 for distributor blanking plate if required
1 in stock
£395.00
INC VAT
£329.17 EX VAT
Brush holder for Bosch alternator stator
Also known as Guzzi ref. 17712454, 14712452
Includes brushes. See ELA17453
This part is due back in stock soon, call 01484 841395 to reserve yours
17712452 GU17712452 17 71 24 52
1771 2452 1771.2452 17.71.24.52
£68.30
INC VAT
£56.92 EX VAT
Alternator stator for Bosch charging systems, this does not include the plate and brush holders
To fit this you will need to solder in the three wires from the windings. Replacement rotors and brushes also available. See ELA00503 for a complete higher output upgrade for your charging system
This part is available by special order, request a quote
17712400 GU17712400 17 71 24 00
1771 2400 1771.2400 17.71.24.00
£148.50
INC VAT
£123.75 EX VAT
Bosch alternator stator, this may not include the plate and brush holders
Sorry this part cannot be shipped to the US or Canada
6 month warranty on this part
1 in stock, request a quote
17712400 GU17712400 17 71 24 00
1771 2400 1771.2400 17.71.24.00
Prices from
£30.00 - £110.00
inc VAT dependent on condition
Alternator stator for Saprisa charging systems
May be supplied with rotor
Sorry this part cannot be shipped to the US or Canada
6 month warranty on this part
Sorry, this part is no longer available.
28712400 GU28712400 28 71 24 00
2871 2400 2871.2400 28.71.24.00
Prices from
£90.00 - £180.00
inc VAT dependent on condition
Complete 12v 300w alternator for Saprisa charging systems
No longer in production
Sorry, this part is no longer available.
28712400 GU28712400 28 71 24 00
2871 2400 2871.2400 28.71.24.00
Sorry this item is out of production
Alternator rotor for Saprisa charging systems
Fits tapered crankshaft
Sorry this part cannot be shipped to the US or Canada
6 month warranty on this part
12 in stock
28712400 GU28712400 28 71 24 00
2871 2400 2871.2400 28.71.24.00
£15.00
INC VAT
£12.50 EX VAT
Stainless steel tool for removing Bosch alternator rotor. Will also fit Saprisa.
Simply screw in until the rotor pops off
2 in stock
Also fits Benelli Sei 900 (Series 2)
£6.60
INC VAT
£5.50 EX VAT