Shop headings: New Spares | Used Spares | Accessories | Brands
Dellorto PHF36 DS left hand carb. This is a flat top carb with 90° angle adapter for the throttle cable. Supplied with cable choke set up. Carb body is darker than earlier versions
44mm inlet manifold connection, includes accelerator pump. These can be fitted to T3, Convert, 1000 SP and T4 if FUA30611 is fitted.
Carb normally supplied in the following specification:
This part is available by special order, request a quote
28112651 GU28112651 28 11 26 51
2811 2651 2811.2651 28.11.26.51
£330.00
INC VAT
£275.00 EX VAT
Dellorto PHF36 DD right hand carb. This is a flat top carb with 90° angle adapter for the throttle cable. Supplied with cable choke set up. Carb body is darker than earlier versions
44mm inlet manifold connection, includes accelerator pump. Supplied with single banjo connector. These can be fitted to T3, Convert, 1000 SP and T4 if FUA30611 is fitted.
Carb normally supplied in the following specification:
This part is available by special order, request a quote
28112650 GU28112650 28 11 26 50
2811 2650 2811.2650 28.11.26.50
£330.00
INC VAT
£275.00 EX VAT
Pod type air filter for increased air flow
Made from a high performance twin layer foam this K & N type air filter is designed to offer improved and unrestricted airflow whilst offering adequate filtration. Washable and reusable (use hot soapy water). Best run dry for road. Fits PHF 30 and PHF 36 Dellorto carbs. You may find that a 5-10% increase in main jet size helps to make the most of the increased air flow with this filter
This part is available by special order, request a quote
£22.50
INC VAT
£18.75 EX VAT
Long alloy bellmouth / trumpet intake with domed mesh for Dellorto PHF 30 and 36 carbs, screws to rear of carb replacing air filter
2 in stock
£52.00
INC VAT
£43.33 EX VAT
Short alloy bellmouth / trumpet intake with domed mesh for Dellorto PHF 30 and 36 carbs, screws to rear of carb replacing air filter
2 in stock
£46.00
INC VAT
£38.33 EX VAT
Manually operated fuel tap or fuel valve for models with carbs. Includes cable and remote side panel mounted knob
These new taps have a linkage that may be shorter than the original tap. In this case, you will need to swap over the linkage from your old tap and re-use it. Before using the tap you will need to release it by rotating the brass section behind the tap by quarter of a turn (anti-clockwise)
This part is due back in stock soon, call 01484 841395 to reserve yours
29105450 GU29105450 29 10 54 50
2910 5450 2910.5450 29.10.54.50
£35.00
INC VAT
£29.17 EX VAT
Fuel level sender for fuel tank
2 pin connector block. Use seal TAA90103 with this part
This part is due back in stock soon, call 01484 841395 to reserve yours
29103050-z 29103050 GU29103050 29 10 30 50
2910 3050 2910.3050 29.10.30.50
£29.30
INC VAT
£24.42 EX VAT
Fuel level sender for fuel tank
2 pin connector block. Use seal TAA90103 with this part
Availability varies on this part, check availability
30103060 GU30103060 30 10 30 60
3010 3060 3010.3060 30.10.30.60
£31.20
INC VAT
£26.00 EX VAT
Dellorto K18 slide needle
Standard needle clip position is 3rd groove from top
This part is due back in stock soon, call 01484 841395 to reserve yours
£13.10
INC VAT
£10.92 EX VAT
Oil temperature sensor
See ELA03330 for sensor support
This part is due back in stock soon, call 01484 841395 to reserve yours
29724961 GU29724961 29 72 49 61
2972 4961 2972.4961 29.72.49.61
£30.00
INC VAT
£25.00 EX VAT