Shop headings: New Spares | Used Spares | Accessories | Brands
This section contains switches, sensors, relays and other electrical items
Alternator upgrade kit for Bosch systems containing stator windings, wound rotor and replacement diode board. The superior design alternator has an output up to 300% greater than the original Bosch system. You may wish to fit a plastic alternator spacer ENA18150 if your model does not have one of these already (to improve cooling of the alternator). You will need front crank seal ENA90428 (Bosch seal) if you wish to fit this to a bike with a Saprisa charging system. This kit reuses your existing Bosch regulator and stator plate with brush holder, see ELA29703 for a replacement regulator and ELA17452 for brush holders.
This part is available by special order, request a quote
£465.00
INC VAT
£387.50 EX VAT
Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 12 volt coils and can be used to replace points or Bosch electronic ignition on models with Bosch charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.
2 year warranty on Sachse ignition kits
Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. We recommend fitting Dyna coils ELA14101 with this kit. If you wish to combine this kit with uprated charging system ELA00502 you will need to make or source longer studs (M5 x 67mm x 2) for pickup, and longer centre bolt (M8 x 58mm wasted). See ACA50001 for distributor blanking plate if required
1 in stock
£395.00
INC VAT
£329.17 EX VAT
Complete Newtronic electronic ignition kit containing ignition pickup (distributor mounted) and ignition box. Retains original mechanical advance / retard mechanism.
Kit consists of sensor plate and pickups, magnet, ignition box, clip, screws and instructions.
Suitable for all models originally fitted with points which have a mechanical advance / retard . Can also be fitted to Strada 1000, Spada 3, Cali 3 etc... if the distributor is swapped for a points type part with advance / retard mechanism. Coils should have 4 Ohms resistance on the low tension circuit, OE coils will work OK but you may see improved results with high performance Dyna coil ELA14101
Developed from the original Piranha system, Newtronic ignitions are contact breaker replacement ignition systems covering a range of Japanese and European motorcycles from the late 1950's onwards. Using contactless, maintenance free, infra red triggering the Newtronic ignition has gained a reputation for ease of installation and effectiveness from satisfied motorcyclists around the World. The switching units include an integrated timing LED for each channel, making it quick and easy to accurately time each cylinder independently (an essential step in gaining the best performance from your engine.). The system typically consists of three main components:
1 in stock
£225.00
INC VAT
£187.50 EX VAT
Pair of performance Dyna 12 volt 5 ohm single lead ignition coils with angled HT lead socket. These are a cooler running coil that offer improved starting and performance
Dyna Performance Replacment Coils are high tech, top quality coils, designed for maximum performance. They produce spark voltages in excess of 30,000 volts and spark energies second to none. Dynatek coils are available in a wide variety of resistances and output configurations to allow easy replacement of stock coils. Dynatek coils work with factory electronic ignitions, points, and aftermarket ignitions.
These are a different size and shape from the original coils so you will need to fabricate a suitable coil mount.
Individual coils available by special order, call us for details. See ELA00001 for crimp on HT lead connector
1 in stock
1471650
£190.00
INC VAT
£158.33 EX VAT
Pair of high performance Dyna 12 volt 5 ohm dual lead ignition coils with angled HT lead socket. These are a performance coil which offer improved starting and performance for twin plugged models
Dyna Performance Replacment twin plug coils are high tech, top quality coils, designed for maximum performance. They produce spark voltages in excess of 30,000 volts and spark energies second to none. Dynatek coils are available in a wide variety of resistances and output configurations to allow easy replacement of stock coils. Dynatek coils work with factory electronic ignitions, points, and aftermarket ignitions.
These are a different size and shape from the original coils so you will need to fabricate a suitable coil mount. Guzziology recommends using electronic ignition with these coils as points may not be up to triggering these coils. See ELA00001 for crimp on HT lead connector.
Individual coils available by special order, call us for details
This part is available by special order, request a quote
1471650
£190.00
INC VAT
£158.33 EX VAT
Reconditioned starter motor and solenoid in black and silver finish. Professionally reconditioned and sold with a 12 month guarantee. This is a suitable replacement for Bosch 8 or 9 tooth Guzzi starter motors. See ELA14738 for replacement solenoid.
This may fit Loop frame models with 5 speed gearboxes, you will need to trim a clearance into the battery tray to make room. The clutch cable bracket will prevent fitment on 4 speed models.
This is an exchange only item, we can supply these before receiving your exchange unit subject to a refundable deposit so you can keep your bike on the road. See ELC10737 for the refundable deposit. Send your old starter motor to our registered address. NB In case of starter motor problems do not tap the casing as this will certainly cause it to fail. See SSA08075 for mounting bolts. Do not remove second nut from terminal posts when fitting - this nut is required to hold the terminal in place
1 in stock
14730554 GU14730554 14 73 05 54
1473 0554 1473.0554 14.73.05.54
£155.00
INC VAT
£129.17 EX VAT
Motobatt quadflex 30Ah battery. Quadflex technology means you have two positive and two negative threaded terminals allowing maximum flexibility when installing. This powerful battery produces a massive 390 cranking amps, and is rated at 32 ah.
These sealed absorbed glass matt batteries have been used in military and off road applications for many years.
They offer increased lifespan, higher vibration resistance and electrical performance. This battery is also leak, vibration and spill proof if installed correctly.
Supplied fully charged and ready to fit.
NB This battery must not be trickle charged or charged using a traditional manual charger, AGM batteries require a smart charger - we recommend ACA96000
For more information on charging AGM batteries see these FAQ's.
This is a better value replacement for the Odyssey PC925 battery. Replaces Guzzi refs. 14704550, 18704550, 28704550, 28704545, 28704551, 28704552, 14704551, 14704500 and 14704505
One year warranty on all our Motobatt batteries.
Slightly taller than original loop frame battery so you may need to make some modification to retaining bracket
Please note this part CANNOT be posted outside of the UK mainland area
1 in stock
03704540-z 03704540 GU03704540 03 70 45 40
0370 4540 0370.4540 03.70.45.40
£155.00
INC VAT
£129.17 EX VAT
Alternator stator for Bosch charging systems, this does not include the plate and brush holders
To fit this you will need to solder in the three wires from the windings. Replacement rotors and brushes also available. See ELA00503 for a complete higher output upgrade for your charging system
This part is available by special order, request a quote
17712400 GU17712400 17 71 24 00
1771 2400 1771.2400 17.71.24.00
£148.50
INC VAT
£123.75 EX VAT
Combined regulator rectifier to replace separate items on Bosch equipped models. See our wiring instructions page for help installing this reg/rec.
Includes harness extension with 6 spade connector block. NB this reg/rec should not be used with a lithium-ion battery
Sorry, this part is no longer available.
Sorry this item is out of production
Combined regulator rectifier to replace separate items on Bosch equipped models. See our wiring instructions page for help installing this reg/rec.
Supplied with long leads for battery and alternator connection. Female spades for alternator and charge sensing, ring connectors for battery. NB this reg/rec should not be used with a lithium-ion battery
This part is due back in stock soon, call 01484 841395 to reserve yours
£140.00
INC VAT
£116.67 EX VAT