Shop headings: New Spares | Used Spares | Accessories | Brands
Regulator rectifier for Saprisa charging systems
Male spade connectors on regulator, may be supplied with 7 connectors - see the diagram on our technical documents page for help installing this part. The standard black block connector is not compatible with the updated 7 pin reg/rec, you will instead need to fit female spade connectors to your wires.
This part is due back in stock soon, call 01484 841395 to reserve yours
28703800-z 28703800 GU28703800 28 70 38 00
2870 3800 2870.3800 28.70.38.00
£85.00
INC VAT
£70.83 EX VAT
Rectifier / diode board for Bosch charging systems. High quaility replacement part sourced from Germany
See our Bosch fault finder page for help diagnosing problems on your Bosch charging system.
1 in stock
17704300-z 17704300 GU17704300 17 70 43 00
1770 4300 1770.4300 17.70.43.00
£95.00
INC VAT
£79.17 EX VAT
Red NGK spark plug resistor cap with rubbers
Also known as suppressor cap
This part is due back in stock soon, call 01484 841395 to reserve yours
£6.00
INC VAT
£5.00 EX VAT
Red NGK spark plug resistor cap with rubbers
Also known as suppressor cap
Sorry, this part is no longer available.
LD05F
Sorry this item is out of production
Black NGK spark plug resistor cap with rubbers
Also known as suppressor cap
This part is due back in stock soon, call 01484 841395 to reserve yours
LD05F
£4.50
INC VAT
£3.75 EX VAT
Iridium tipped NGK BPR7EIX high performance spark plug
Designed specifically for the performance enthusiast. Iridium offers extreme ignitability, improved throttle response and superior anti fouling
2 in stock
£16.00
INC VAT
£13.33 EX VAT
Pair of performance Dyna 12 volt 5 ohm single lead ignition coils with angled HT lead socket. These are a cooler running coil that offer improved starting and performance
Dyna Performance Replacment Coils are high tech, top quality coils, designed for maximum performance. They produce spark voltages in excess of 30,000 volts and spark energies second to none. Dynatek coils are available in a wide variety of resistances and output configurations to allow easy replacement of stock coils. Dynatek coils work with factory electronic ignitions, points, and aftermarket ignitions.
These are a different size and shape from the original coils so you will need to fabricate a suitable coil mount.
Individual coils available by special order, call us for details. See ELA00001 for crimp on HT lead connector
This part is due back in stock soon, call 01484 841395 to reserve yours
1471650
£190.00
INC VAT
£158.33 EX VAT
Pair low and high chrome Voxbell horns. Rear of horn is black, two connection terminals on one horn, four on the other
This part is due back in stock soon, call 01484 841395 to reserve yours
14743700 GU14743700 14 74 37 00
1474 3700 1474.3700 14.74.37.00
Also fits Laverda
£87.00
INC VAT
£72.50 EX VAT
Oil pressure sender, M12 thread, male bullet connector
Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.
See ENA12640 for replacement crush washer if required
More than 5 in stock
17768750 GU17768750 17 76 87 50
1776 8750 1776.8750 17.76.87.50
£10.00
INC VAT
£8.33 EX VAT
Oil pressure sender
Can also be used in place of oil pressure switch 17768750 and adapter 19055800 on Monza (check which type your small twin uses before replacing). Replaces two part sensor 31999581.
See ENA12640 for replacement crush washer if required
2 in stock
19768720-z 19768720 GU19768720 19 76 87 20
1976 8720 1976.8720 19.76.87.20
£15.50
INC VAT
£12.92 EX VAT