Rebuild kit for Brembo PS 13 handlebar mounted brake and clutch master cylinders, includes all seals, return spring and brake grease. Piston is hollow

This seal kit is for Cali 1100 master cylinders with a hollow pivot pin, does not fit early models with a solid pivot pin. For Cali EV models this only fits master cylinders with a pair of screws in the middle of the cap, it does not fit the later master cylinder which has diagonally opposed screws. Also know as Guzzi ref. 28659378, 000043851, 30659330. NB Included instructions may refer to rear master cylinder applications rather than front. Brembo ref. 110436250

 1 in stock

Also fits Cagiva Elefant E750, Ducati 748

Clutch cable for pre 1988 models with left hand switchgear integrated into clutch lever clamp

 1 in stock

28093060-z 28093060 GU28093060 28 09 30 60
 2809 3060 2809.3060 28.09.30.60

Clutch cable

 1 in stock

 28093078 GU28093078 28 09 30 78
 2809 3078 2809.3078 28.09.30.78

Clutch plate kit consisting of 2 x friction plates, 1 x intermediate plate, deep splined clutch centre / boss and tabbed lock washer (not shown). For models with the early type shallow spline plates this is a worthwhile upgrade kit to the better deep splined centre and plates. Clutch plate alignment tool also available, see TOA30510. Suitable for all 5 speed dual plate clutch models

Save £20 on the cost of these components if bought seperately. Does not include clutch springs (see CLA13100). Thicker side of each friction plate should face transmission

 1 in stock

Rubber cover for Domino clutch lever and choke cable

Clutch cable rubber

 1 in stock

 27663815 GU27663815 27 66 38 15
 2766 3815 2766.3815 27.66.38.15

Clutch thrust bearing complete, sits in recess in rear gearbox casing.

This bearing is the higher quality OE bearing used on recent models

 1 in stock

2A000376

Clutch adjustment bolt for gearbox rear, adjusts freeplay on clutch arm

Adjuster screw, see GEA92508 for nut

 1 in stock

 14090400 GU14090400 14 09 04 00
 1409 0400 1409.0400 14.09.04.00

Clutch pushrod

 1 in stock

 14085700 GU14085700 14 08 57 00
 1408 5700 1408.5700 14.08.57.00

Clutch pushrod for RAM clutch which is 5mm longer than the standard version. This may be needed when fitting a RAM clutch kit to give extra room for adjustment

 1 in stock

New type clutch friction plate for models with deep splines with deep splined centre

2 plates required- thicker side of each friction plate should face transmission.
Also known as Guzzi ref. 30084410, 03084400, 29084450
V11 Tenni, Rosso Mandello and Scura have a single plate clutch which uses a different friction plate (unfortunately out of production)

These can be fitted to earlier 850 and 1000 models if the early shallow splined clutch centre is replaced with the later deep splined type. See our kit CLA20302 to update early 850/1000 models. Clutch plate alignment tool also available, see TOA30510

 This part is due back in stock soon, call 01484 841395 to reserve yours

 05084430 GU05084430 05 08 44 30
 0508 4430 0508.4430 05.08.44.30