Shop headings: New Spares | Used Spares | Accessories | Brands
Pair of YSS rear shock absorbers, milled aluminium body with black springs.
Continuous preload adjustment, fully rebuildable
This part is available by special order, request a quote
£210.00
INC VAT
£175.00 EX VAT
Polished aluminium instrument console kit for 80mm instruments (as used on Le Mans 1, 2, T3, V50 etc...). This high quality kit is specially made for Gutsibits and consists of the following parts:
Manufactured from 6mm aluminium, this this instrument binnacle will not fatigue with use and is an excellent way to present the standard 80mm Veglia instruments. Bolts to handlebar yoke clamps. NB instruments and ignition switch shown in photo for illustration purposes only.
This is a high quality UK manufactured part made exclusively for Gutsibits, do not confuse with lesser alternatives. These kits are often prepared to order so please allow for a couple of days delay before your order is sent.
NB This kit works with the ignition switch ELA17735, later type switches will not fit into the predrilled ignition switch hole. On models with cable operated remote odometer resets the reset knob will need to be relocated. Check the depth of your instruments before ordering, this kit is intended for 48mm deep instruments with 60mm stud centres
Instruments with 60 degree or similar angle drives to the rear will require you to enlarge cable cutouts in the plates that make up the rear of the kit
1 in stock
£205.00
INC VAT
£170.83 EX VAT
Extreme performance hybrid maintenance free Motobatt 12 volt battery. MFLEX technology means you have adjustable terminal options and maximum flexibility when installing.
We have sourced this battery especially for high compression big twins which need enhanced cranking amps for starting. Suitable for special builds with non standard battery locations (e.g. under the gearbox). This hybrid battery offers 330 cranking amps for reliable and hassle free starting. This is at least 100% more cranking amps than comparable lead acid or AGM batteries
Superior conductivity from pure copper terminals.
Compared to traditional lead acid batteries a hybrid battery is
Order now and we will post your order within 7 days.
638733 MG638733
£180.00
INC VAT
£150.00 EX VAT
£175.00
INC VAT
£145.83 EX VAT
Pair of stylish Kappa soft panniers, perfect for V7 and V9 models.
Order now and we will post your order within 7 days.
£168.00
INC VAT
£140.00 EX VAT
HIgh performance aluminium velocity stack for airbox to throttle body union. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM
This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10434
Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.
This part is available by special order, request a quote
£150.00
INC VAT
£125.00 EX VAT
This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.
Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.
See installation instructions here.
This part is available by special order, request a quote
£149.00
INC VAT
£124.17 EX VAT
Progressive fork spring kit for Kaifa forks, supplied complete with fork oil.
These progressive fork springs improve ride quality and handling by responding progressively to the road. The more the spring is compressed the harder it becomes preventing the forks from bottoming out.
Hyperpro are a Dutch company with over two decades of experience in manufacturing innovative top-level suspension. Famed for their development of progressive suspension, they produce a full range of products to transform any bike's performance.
The front fork spring kits comes complete with progressive springs, the correct weight fork oil, and a full installation & set-up manual providing the optimum settings, allowing you to set your bike up correctly.
The effectiveness of your suspension affects braking, handling, comfort, safety and performance so Hyperpro products represent one of the best modifications that can be made to any motorcycle
This part is available by special order, request a quote
£145.00
INC VAT
£120.83 EX VAT
£140.00
INC VAT
£116.67 EX VAT