Standard short 10 spline driveshaft

 This part is due back in stock soon, call 01484 841395 to reserve yours

12326300-z 12326300 GU12326300 12 32 63 00
 1232 6300 1232.6300 12.32.63.00

Round Bosatta chrome finish tail light without support bracket. Includes bulb holder, anti vibration rubber and section to illuminate numberplate

Attaches via 2 M6 studs. Smaller version available in black. Replaces Guzzi ref. 14474901, 12740900, 12740901, 10474900

 This part is due back in stock soon, call 01484 841395 to reserve yours

 10740900 GU10740900 10 74 09 00
 1074 0900 1074.0900 10.74.09.00

CEV type lights (off/pilot/on), main beam and horn switch. Supplied without wires, you will need to solder your wiring into the switchgear using a minimum 60W soldering iron. Switch fixes to handlebars using included screws

Can be fitted to left or right side of bars

 Availability varies on this part, check availability

12746001-z 12746001 GU12746001 12 74 60 01
 1274 6001 1274.6001 12.74.60.01

Complete gasket kit

 This part is available by special order, request a quote

Front right hand brake cable with inline brake light switch for drum brake

Includes adjuster at lower end. Two male spade connectors for brake light switch

 This part is available by special order, request a quote

 13625560 GU13625560 13 62 55 60
 1362 5560 1362.5560 13.62.55.60

Shallow splined Newfren clutch friction plate for big twins with old shallow splined clutch centre

2 plates required per clutch overhaul- thicker side of each plate should face transmission. Also check your intermediate plate 12082300. This has shallower splines than the Spada 3 on plates. These are the best fit if you still have the original shallow spline clutch hub

 This part is available by special order, request a quote

28084460-z 28084460 GU28084460 28 08 44 60
 2808 4460 2808.4460 28.08.44.60

12 volt single output 3 Ohm ignition coil (lead to distributor)

Push fit HT lead, see ELA00001 for crimp on HT lead connector. Supplied without coil clamp

 This part is due back in stock soon, call 01484 841395 to reserve yours

 26716504 GU26716504 26 71 65 04
 2671 6504 2671.6504 26.71.65.04

Prolong battery life with this 9 stage smart battery charger, suitable for 6v, 12v AGM and lead acid batteries.

Weatherproof - suitable for use outside 6V / 12V 1A Auto-sensing charger. Suits all AGM, Lead Acid, Calcium and Gel batteries Charges 6v and 12v batteries Ring terminal and alligator clip harnesses included Spark proof Maintains full charge Simple, connect and wait for green light Overload / Short circuit protection See ACA96001 for a spare set of charging leads (e.g. for a separate bike).

 1 in stock

Pair of Tommaselli chromed headlight brackets with anti vibration rubber collars and silver finish aluminium brackets. To fit 35mm and 36mm diameter forks.

 This part is due back in stock soon, call 01484 841395 to reserve yours

Polished aluminium clutch lever

 This part is available by special order, request a quote

 12605705 GU12605705 12 60 57 05
 1260 5705 1260.5705 12.60.57.05