Pair of engine crash bars for V7 models (including single throttle body models) finished in bright chrome. The heads and rocker covers are vulnerable on these bikes and can be badly damaged by even a minor accident, replacement cost can be more than £1000 so protect your bike with these bars.

Supplied with fitting hardware, this crashbar has been specially developed for the later V7 head design. Engine bars - essential protection for your bike.

 This part is available by special order, request a quote

This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.

Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.

See installation instructions here.

 1 in stock

Pair of adjustable Tarozzi clipons, quality aluminium castings and chrome plated tube

38mm rise

 Sorry, this part is no longer available.

Pair of chrome reverse cone mega type silencers supplied with shims to allow fitment to a variety of models. Adjustable mounting bracket and clamp included.

You may need to modify brackets or fabricate your own depending upon which model you have

 This part is available by special order, request a quote

Complete ignition switch with lock number, keys and steering lock plate

4 pin superseal connector included, Zadi switch has 4 positions

 Sorry, this part is no longer available.

 01782500 GU01782500 01 78 25 00
 0178 2500 0178.2500 01.78.25.00

High performance aluminium velocity stack for airbox to throttle body union on single throttle body models. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM

This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10434

Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.

 This part is due back in stock soon, call 01484 841395 to reserve yours

Clutch friction plate

 This part is available by special order, request a quote

2A000770

Replacement regulator rectifier for models fitted with the Ducati charging system. This is a quality unit and is supplied with fitting instructions

Connections: 2 x yellow male bullet, 1 x white female bullet, 1 x black ring, 1 x red ring. You will need to reuse your existing block connectors to connect this to your loom. See this wiring diagram for wiring connections

 This part is due back in stock soon, call 01484 841395 to reserve yours

37703805-z 37703805 GU37703805 37 70 38 05
 3770 3805 3770.3805 37.70.38.05

Rocker cover or head cover

Fits left and right hand cylinders

 This part is available by special order, request a quote

 887523 MG887523

Rear brake master cylinder, foot operated. Brembo no longer offer overhaul kits for recent models so this is your only option if your master cylinder is faulty.

 This part is available by special order, request a quote

2B000508