Alternator stator for Bosch charging systems, this does not include the plate and brush holders

To fit this you will need to solder in the three wires from the windings. Replacement rotors and brushes also available. See ELA00503 for a complete higher output upgrade for your charging system

 This part is available by special order, request a quote

 17712400 GU17712400 17 71 24 00
 1771 2400 1771.2400 17.71.24.00

Black steel centre stand without springs or brackets

Brackets, bushes and springs available separately.
Note that as with the original stand the lugs on this stand are only intended for pushing the stand to the ground and are not stong enough to lever your bike onto the stand. You should put your foot onto the foot of the stand to rock the bike back and up on to it

 Sorry, this part is no longer available.

17430345-z 17430345 GU17430345 17 43 03 45
 1743 0345 1743.0345 17.43.03.45

Centre stand finished in black, supplied without springs or fitting hardware

This stand has the narrow foot spacing so will not fit later California models with wider rear wheels

 Sorry, this part is no longer available.

 29430300 GU29430300 29 43 03 00
 2943 0300 2943.0300 29.43.03.00

Replacement clutch plate for single plate RAM clutches

Torque setting for fitting this is 25Nm with a thread locking compound

 This part is available by special order, request a quote

Rear main bearing flange

 This part is available by special order, request a quote

12011400-z 12011400 GU12011400 12 01 14 00
 1201 1400 1201.1400 12.01.14.00

Chromed fork stanchion

 This part is available by special order, request a quote

 63525400 GU63525400 63 52 54 00
 6352 5400 6352.5400 63.52.54.00

Also fits Benelli Sei 750 (series 2)

Complete twin bleed F09 (P9) front left hand (when mounted behind fork leg, otherwise use as RH) replica Brembo brake caliper. Also rear caliper (when mounted above and behind rear wheel spindle). Supplied with bleed nipples, dust cover, pins and spring. This can replace the P9 rear caliper as fitted to a 1000 SP, or can be used as a performance upgrade to replace the smaller piston P8 caliper fitted as standard to many Guzzis. Please see Guzziology for advice on how to perform this conversion.

Brake pads not included- see BRA33204

 This part is available by special order, request a quote

Complete twin bleed F09 (P9) front right hand (when mounted behind fork leg, otherwise use as LH) replica Brembo brake caliper. Supplied with bleed nipples, dust cover, pins and spring. This can be used as a performance upgrade to replace the smaller piston P8 caliper fitted as standard to many Guzzis. Please see Guzziology for advice on how to perform this conversion.

Brake pads not included- see BRA33204

 This part is available by special order, request a quote

Rear main bearing flange, second oversize: + 0.4mm

 This part is available by special order, request a quote

12011402-z 12011402 GU12011402 12 01 14 02
 1201 1402 1201.1402 12.01.14.02

Rear main bearing flange, third oversize: + 0.6mm

 This part is available by special order, request a quote

12011403-z 12011403 GU12011403 12 01 14 03
 1201 1403 1201.1403 12.01.14.03