Stainless steel M8 dome head nut, used for exhaust studs, gearbox and drive box studs

Many applications including gearbox, exhaust and bevel box mounts on big twins, V7 850, V85TT and V100. Also used on small twins for bevel box mount bolts. Also known as Guzzi ref. 860651

 More than 5 in stock

Stainless steel after market exhaust stud

M6 exhaust stud. See ENA31881 for stud nut. Note that unlike the originals these studs are threaded along their entire length.

 More than 5 in stock

 96506042 GU96506042 96 50 60 42
 9650 6042 9650.6042 96.50.60.42

Exhaust gasket. Please note that these may need to be trimmed down slightly to fit a V35 / V50. See ENA22040 for alternative

Also known as Guzzi ref. 61025280 19025280. ENA22040 can be used in place of this gasket

 More than 5 in stock

 61025200 GU61025200 61 02 52 00
 6102 5200 6102.5200 61.02.52.00

M6 wavy washer

Also known as Guzzi ref. 95129115

 More than 5 in stock

 03013800 GU03013800 03 01 38 00
 0301 3800 0301.3800 03.01.38.00

Stainless steel exhaust stud nut, this is a less expensive alternative to the genuine nut

 More than 5 in stock

31121880-z 31121880 GU31121880 31 12 18 80
 3112 1880 3112.1880 31.12.18.80

Insulating washer, used for attaching exhaust heatshield

 More than 5 in stock

AP8221297

Exhaust gasket, silencer bush or muffler gasket shim for exhaust joint between silencer and downpipe

2 exhaust bushes required per bike

 2 in stock

 91113826 GU91113826 91 11 38 26
 9111 3826 9111.3826 91.11.38.26

This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.

Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.

See installation instructions here.

 1 in stock

Exhaust stud, see ENA96043 for less expensive alternative

See ENA31880 for stud nut

 This part is available by special order, request a quote

 96506042 GU96506042 96 50 60 42
 9650 6042 9650.6042 96.50.60.42

Collet for exhaust manifold, two required per cylinder

 This part is due back in stock soon, call 01484 841395 to reserve yours

19025460-z 19025460 GU19025460 19 02 54 60
 1902 5460 1902.5460 19.02.54.60