Ignition pickup and tacho sensor

Connector plug has two male spades. Also known as phase sensor. Used on models with the large Marelli P8 ECU. No longer available from Guzzi. Note 90° angle where cable exits sensor. See ENA90141 for O ring used to fit this part

 1 in stock

 29721660 GU29721660 29 72 16 60
 2972 1660 2972.1660 29.72.16.60

Oil temperature sensor

See ELA03330 for sensor support

 1 in stock

 29724961 GU29724961 29 72 49 61
 2972 4961 2972.4961 29.72.49.61

Ducati type alternator stator

300W output, doesn't include rotor / magnet. Also known as Guzzi ref. 30712460

 1 in stock

 37712405 GU37712405 37 71 24 05
 3771 2405 3771.2405 37.71.24.05

Brush kit for overhauling Bosch starter motor

The brush connections need to be soldered

 1 in stock

Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 12 volt coils and can be used to replace points or Bosch electronic ignition on models with Bosch charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. We recommend fitting Dyna coils ELA14101 with this kit. If you wish to combine this kit with uprated charging system ELA00502 you will need to make or source longer studs (M5 x 67mm x 2) for pickup, and longer centre bolt (M8 x 58mm wasted). See ACA50001 for distributor blanking plate if required

 1 in stock

6 pin male block connector, used for main loom connections. See ELA30001 for female 6 block connector.

 1 in stock

200073020

Black Magneti Marelli plastic distributor cover for models with points or most electronic ignitions (not Piranha)

See SSA05025 for the screws which secure this dizzie cap

 1 in stock

 14715420 GU14715420 14 71 54 20
 1471 5420 1471.5420 14.71.54.20

4 pin male block connector arranged in two rows of two used for main loom connections. See ELA17738 for the Molex connectors that go in this block. Use female molex connectors with this block

 1 in stock

Halogen headlight bulb H1 12V 55W. Used for main beam.

Also known as Guzzi ref. 30530557

 1 in stock

 580141 MG580141

Universal hydraulic brakelight switch. This hydraulic switch replaces discontinued brake light switches by bolting in place of a double banjo bolt on the handlebar or rear brake master cylinder

Especially suitable for replacing the standard switch on models where the front brakes have been 'de-linked'

 1 in stock